在线字典为您在线查询料气的词典内容如下，包括料气的拼音，读音，拼读；料气的意思和详细释义，料气的近反义词，料气的英语翻译，用料气这个词语怎么造句等内容。
料气读音/繁体/五笔/英文翻译
| 拼音 | liào qì | 读音 | 跟我读 |
|---|---|---|---|
| 繁体 | 料氣 | 类型 | 词语大全 |
| 五笔 | 此词无五笔连打 | 平音 | liaoqi |
| 词性 | 中性 | 语法 | |
| 拼读 | 了(le1)衣(yi1)奥(ao4)，料(liao4)|七(qi1)异(yi4)，气(qi4) | ||
| 英语翻译 | 燃料气[油气]fuel gas;FG |
料气是什么意思？
· 基本释义
犹才气。
· 详细释义
犹才气。
《醒世姻缘传》第二三回：“这两个孩子又煞作怪，谁想把他父亲的料气尽数都得来与了这两个儿子，真是过目成诵。”
· 网络释义
liào qì ㄌㄧㄠˋ ㄑㄧˋ犹才气。
料气的近反义词？
料气近义词：抱歉，查无料气的近义词
料气反义词：抱歉，查无料气的反义词
料气词语接龙
（~料气~）在开头的接龙：气象，气压，气馁，气概，气愤，气魄，气息，气节，气质，气忿，气枪，气锤，气管，气垫，气喘，气焊，气度，气功，气割，气门
（~料气~）在结尾的接龙：空气，天气，生气，力气，香气，大气，正气，人气，名气，才气，闭气，叹气，洋气，骨气，客气，运气，吸气，哈气，景气，丧气
暂时无法为您进行料气的词语顺序接龙!
用料气怎么造句？
您好，暂未查询到料气造句的内容。
介绍气力输送管道的变径设计方法和变径管道气力输送试验中压损、料气比、物料质量流量等间的关系。
A method of stepped-diameter design for pneumatic conveying pipelines, as well as relationship among pressure loss, ratio of material to air, and mass flow rate of materials etc.
针对长江原水浊度较高的特点，采用了两级高效反应沉淀池、均质石英砂滤料气水反冲洗滤池处理工艺。
Considering the high turbidity of the Yangtze River water, two-stage high efficient reaction and sedimentation tanks, and sand filter with air-water backwashing are employed.
本文介绍了“原位冷凝”式弹丸注入器先行实验及中国环流器一号HL-1弹丸加料实验中采用的丸料气和推进剂系统；
In this paper, the fuel gas and propellent system of "in site" Pellet injector used in beforehand experiment and Pellet fueling experiment in HL-1 Tokamak has been introduced.
所以DCT设计的送料系统使用“气刀”“冠状物”和真空吸盘来分离和吸取这些料片。
So DCT produces blank feeding systems that use "air knives," "rooster combs," and vacuum lifting to separate and lift the sheets.
产品与其它外加剂相容性好，与膨胀剂、引气剂等外加剂及粉煤灰等活性掺合料相配合，功能相互补充、相互激发。
Good compatibility with other admixture products, and expansive agent, air-entraining agent admixtures fly ash and such activities admixtures suitably, function complement each other, mutual arousal.
在二相流雾化器的结构设计中，雾化气输送器件和液料输送器件的管径及其径向夹角是其设计的关键。
The diameter of atomizing gas duct and liquid feedstock duct and their crossing angle are vital elements in the design of two phases atomizing nozzle.
放卷、收卷均由气胀轴支撑料卷，更换快捷、撑力均匀、定心准确。
The unwinding equipment and rewinding equipment all adopt air-expansion shaft to bear roll materials, assuring fast replacement, even supporting force and accurate centering.
即主要通过混凝和短时直接曝气对待处理的生活污水作预处理，然后通过河沙或炉渣滤料进行过滤处理。
That is, use coagulation and direct aeration in short time for primarily treatment of domestic sewage, then filter domestic sewage by slag filtration or sands.
基于边界条件替换方法建立了高炉冷却壁本体和捣打料与炉气之间的换热系数计算模型。
A calculation model of the coefficient of heat transfer between gas and stave body and inlaid refractory is built based on the substitution method of boundary condition.
在连续给料外热式回转窑试验台上，以聚乙烯为试验物料进行了热解产气特性、质量平衡以及能量净收益的试验研究。
By the continuous-feeding external-heating rotary kiln, the experimental studies on the gas yield characteristics, mass balance and net energy income of the polyethylene pyrolysis were performed.
通过对PTA气送糟料仓的结构进行疲劳分析和优化，从根本上解决了其裂纹和焊缝撕裂现象。
The problems were essentially resolved through fatigue analysis and optimization of the structure of feed bin of PTA pneumatic transmission channel.
本文用液上气相色谱法在不同温度下测定了不同中和度的含SO42-0～4％的磷铵料浆的平衡氨分压。
In this paper, ammonia equipressures of ammonium phosphate slurry under different neutralization degree and SO42- cone entration(0~4%) are determined using headspace gas chromatography.
研究了顶层进料均匀性、进气及排气方式对多层流化床流化料层高度均匀性的影响。
The top material admission balance, gas admission, gas exhaust effect of the uniformity of fluidized heights in multistage fluidized bed were studied.
钎料的钎焊性能很大程度取决于钎料对基板上的润湿性能，而润湿性能与液态钎料在基板上的液、固、气三相界面的界面张力有关。
The solderability of electronic solders depends to a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.
利用气隙式膜蒸馏实验对料液温度、流率及气隙宽度等操作条件对膜渗透性能的影响进行了测试和分析。
The effects of operation conditions , such as the temperature and flow rate of solution and the width of air-gap on membrane permeability were studied by air-gap membrane distillation.
对气液混合腔内的雾化气流的速度和液料流量进行了计算。
Thevelocity of atomizing gas and the flux of liquid feedstock were accounted.
钎料的钎焊性能很大程度上取决于钎料对基板的润湿性能，而润湿性能与液态钎料在基板上的液、固、气三相界面的界面张力有关。
The solderability depends on a great extent on the wettability, which relates to solid, liquid and gas interfacial tensions of the melted solders on substrates.
利用气隙式膜蒸馏考察了操作温度、料液中难溶盐种类及其饱和度以及料液中不溶颗粒等因素对膜渗透性能的影响。
The effects of operation temperature, salt type, saturation level, and the presence of undissolving solids on the membrane permeability were studied by air-gap membrane distillation.
并且提出负离子元素在膜料蒸发过程中形成气源中心，产生喷溅，从而使薄膜的损伤阈值降低。
The negative ion element will become the gas source center and form an ejection in the process of evaporation of coating material, so decrease the damage threshold of the coatings.
介绍聚丙烯“三井工艺”气相反应器产生块料的原因、预防措施及解决办法。
The cause of undesirable block material in PP gas phase reactor is introduced in the paper, relevant prevention measures and solutions are also introduced.
本文研究了脉冲惰气熔融测定钼中微量氧所用的浴料。
The metal bath to determine microamount oxygen in molybdenum by impulse heating under inert gas is investigated.
它比传统沼气池产气率提高30%，可自动出料，永不换料。
It digesters than traditional gas yield increased by 30%, can automatically feed out and never refueling.
阐述了曝气生物滤池的基本结构、工艺流程、工艺特点及对滤料性质的要求。
This paper expounds the basic structures, technological processes, technical features of biological aerated filter and the requirements for the natures of the filter materials.
熔融提气过程中选用适当的浴料，可以提高氮氧的释放提取率。
If the suitable bath is applied to heating and extracting procedure, the extracting ratio can be increased.
在冷态试验台上研究了循环流化床料腿密相段中不同管束布置方式对气固流动特性的影响。
The influence of the arrangements of pipes on gas solid flow characteristics in the dense section of standpipe in the circulating fluidized bed is studied on a cold state experiment platform.
用植绒PV C料经高频热压成型，倒阀门气嘴，具有双层防漏气渗气功能。
PVC flocking materials used by high-frequency hot press molding, gas valve back up, with both gas permeability and gas leak-proof function.
本文讨论了不同补料成分对主要微生物生理群和产气率的影响。
This paper studied the effect of different materials added during fermentation on the activity of major bacteria physiologic groups and gas-production rate.
为进一步提高聚乙烯粒料包装系统淘析器的分离效率，对系统内气相流场进行了研究和分析。
Three-dimensional flow field in the elutriator of polythene packed system is simulated based on the standard k-e model provided by FLUENT, is studied firstly to improve the separation efficiency.
为进一步提高聚乙烯粒料包装系统淘析器的分离效率，对系统内气相流场进行了研究和分析。
Three-dimensional flow field in the elutriator of polythene packed system is simulated based on the standard k-e model provided by FLUENT, is studied firstly to improve the separation efficiency.
上述为您在线提供的料气的相关内容全部来自在线汉语词典，希望对您学习料气这个词语有帮助。